DNP Supernova Flex Instrukcja Instalacji Strona 1

Supernova™ Flex Installation manual

E5 Mounting screen a. Leave wood packing fixtures attached to ends while mounting screen assembly to wall. b. Using two (2) people, grasp wood fi

E7 Removing wood fixtures a. Remove three (3) end screws from wood packing fixtures and … b. Carefully remove wood packing fixtures from ends of s

E9 Seating cover a. Lift cover onto screen assembly. b. Mate the catches on back of cover to lip on top of screen assembly. c. Rotate cover dow

E11 Powering up (Plug in) PRESS to BEGINInsert the plug of the IR receiver cable into the mini-jack socket in the screen (located next to the RS-2

E12 Checking smooth operation a. Check extension and retraction of screen. b. Ensure that screen retracts smoothly and does not snag on any parts.

F Setup with remote control The remote control has a programmable display with buttons on the screen (soft buttons) and arrow buttons below the scree

Setting a new bottom position • Press [] to go to “Home Page” • Then Press [Flex] • Press the right arrow button and shift to Page 2. • Press &

G Communication IR remote control The screen is operated by the standard protocol, RC5. Please see below for details: The illustration shows a typica

18User commands This section describes most common user commands in detail. Items enclosed in square brackets are optional. Items enclosed in angle b

19i[nfo] Shows system information. info 301 System settings follow Firmware=0.3.6 Serial=0000000016 Bottom=2502 SpeedLimit=50 Position=2502 Speed=0 .

2 This page is blank

x Immediately stops current screen movement. bottom 101 Moving to 2642 x 203 Screen stopped at 1034 12V-Trigger control To operate the Supernova Flex

H Planning guide Use the below information and the size specifications (section I Specifications and dimensions) to determine the placement of the scr

22I Specifications and dimensions Specifications per screen size Distance from screen to wall: 0.8” [20 mm] Power rating: 100-240 VAC, 50/60 Hz, 10

23 www.dnp.dk www.supernovascreen.com

Rev. 2.2 dnp denmark as – Skruegangen 2 – DK – 2690 Karlslunde – Denmark – Tel: +45 46 16 51 00 – Fax: +45 46

3Contents Section Page A Warnings 4 B Required tools 5 C Box contents 5 D Planning 6 E Mounting screen assembly 8 F Setup 15 G Communication 17 H P

A Warnings Caution: a. Do not operate screen before it is installed on wall. b. Follow all installation instructions. Incorrect installation can lea

B Required tools You will need the following tools: Level Phillips screwdriver Power drill Tape measure C Box contents Check box for: Box 1 – Scree

D Planning See planning guide and screen dimensions – sections H & I. D1 Planning screen location a. Locate wall studs or other structural membe

D2 Checking screen dimensions a. Determine space requirements for installation. b. Refer to section H Planning guide and section I Specifications a

E Mounting screen assembly E1 Unpacking bracket hardware a. Unpack two wall brackets. b. Unpack mounting and securing hardware. _____ E2 Lifti

E3 Leveling brackets a. After planning screen location... (using section H Planning guide and section I Specifications and dimensions)b. Mount wal